S
S
UPER
ERVER 5013G-M Manual
Reset Connector
The Reset Button connector is lo-
cated on pins 3 and 4 of JF1. This
connector attaches to the reset
switch on the computer chassis.
See the table on the right for pin
definitions.
Power Fail LED Connector
The Power Fail LED connector is
located on pins 5 and 6 of JF1.
This connector attaches to a
power fail LED on the computer
chassis (not used on the 5013G-
M). See the table on the right for
pin definitions.
Overheat LED Connector
The Overheat LED connector is lo-
cated on pins 7 and 8 of JF1. This
connector attaches to an overheat
warning LED on the computer
chassis. See the table on the right
for pin definitions.
NIC2 LED Connector
The NIC2 LED connector is located
on pins 9 and 10 of JF1. This con-
nector is used to indicate activity
on the LAN2 Ethernet port.
the table on the right for pin defini-
tions.
See
5-12
Reset Button
Pin Definitions
(JF1)
Pin
Number
Definition
3
Reset
4
Ground
Power Fail LED
Pin Definitions
(JF1)
Pin
Number
Definition
5
VCC
6
Ground
Overheat LED
Pin Definitions
(JF1)
Pin
Number
Definition
7
VCC
8
Ground
NIC2 LED
Pin Definitions
(JF1)
Pin
Number
Definition
9
VCC
10
Ground