Table of Contents
Advertisement
S
S
UPER
ERVER 5013G-M Manual
2-6
Checking the Drive Bay Setup
Next, you should check to make sure the peripheral and the IDE drives have
been properly installed and all connections have been made.
1. Accessing the drive bays
All drives can be accessed from the front of the server.
the CD-ROM and floppy drives, you will need to remove the top chassis
cover.
2. Installing a CD-ROM and floppy disk drives
Refer to Chapter 6 if you need to reinstall a CD-ROM and/or floppy disk
drive to the system.
3. Check the IDE disk drives
Depending upon your system's configuration, your system may have an
IDE hard drive already installed. If you need to install an IDE hard drive,
please refer to the appropriate section in Chapter 6.
4. Check the airflow
Airflow is provided by a 10-cm input fan and one (optional) 4-cm cooling
fan.
The system component layout was carefully designed to promote
sufficient airflow through the small 1U rackmount space. Also note that
all power and data cables have been routed in such a way that they do
not block the airflow generated by the fans.
5. Supplying power to the system
The last thing you must do is to provide input power to the system. Plug
the power cord from the power supply unit into a high-quality power
strip that offers protection from electrical noise and power surges. It is
recommended that you use an uninterruptible power supply (UPS).
nally, depress the power button on the control panel to power up the
system.
2-10
For servicing
Fi-
Advertisement
Table of Contents
