Checking The Motherboard Setup - Supero SuperServer 5013G-M User Manual

S S
UPER ERVER 5013G-M Manual
2-5

Checking the Motherboard Setup

After you install the 5013G-M in the rack, you will need to open the unit to
make sure the motherboard is properly installed and all the connections
have been made.
1. Accessing the inside of the 5013G-M (Figures 2-5)
First, release the retention screws that secure the unit to the rack.
Grasp the two handles on either side and pull the unit straight out until it
locks (you will hear a "click").
top cover to the chassis (located just behind the handles).
press the two buttons on the top of the chassis to release the top cover.
There is a large rectangular recess in the middle front of the top cover to
help you push the cover away from you until it stops. You can then lift
the top cover from the chassis to gain full access to the inside of the
server.
2. Check the CPU (processor)
You may have one processor already installed into the system board.
Each processor should have its own heatsink attached.
for instructions on processor installation.
3. Check the system memory
Your 5013G-M server system may have come with system memory al-
ready installed. Make sure all DIMMs are fully seated in their slots. For
details on adding system memory, refer to Chapter 5.
4. Installing add-on cards
If desired, you can install an add-on card to the system. See Chapter 5
for details on installing a PCI add-on card.
5. Check all cable connections and airflow
Make sure all power and data cables are properly connected and not
blocking the airflow.
Also, check the air seals for damage.
the blower fan and beneath the frame cross section that separates the
drive bay area from the motherboard area of the chassis.
Note: Make sure that the air seals are properly installed.
Remove the two screws that secure the
See Chapter 5 for details on cable connections.
2-8
See Chapter 5
The air seals are located under
Next, de-