Table of Contents
Advertisement
S
S
UPER
ERVER 5013G-M Manual
USB Ports
Slim CD-ROM
Power Supply
6-2
Control Panel
The control panel (located on the front of the chassis) must be connected
to the JF1 connector on the motherboard to provide you with system control
buttons and status indicators. These wires have been bundled together in
a ribbon cable to simplify the connection. Connect the cable from JF1 on
the motherboard to JP4 on the Control Panel PCB (printed circuit board).
Make sure the red wire plugs into pin 1 on both JF1 and JP4.
Figure 6-1.
Chassis Front View
Slim Floppy
Figure 6-2.
Chassis
Back Panel I/O Ports
(see page 5-4)
6-2
Control Panel/LEDs
Rear View
33 MHz PCI Slot
Move all
Advertisement
Table of Contents
