Table of Contents
Advertisement
S
S
UPER
ERVER 5013G-M Manual
5-10 Parallel Port, Floppy Drive, Hard Drive and
AGP Connections
Use the following information to connect the floppy and hard disk drive
cables.
• The floppy disk drive cable has seven twisted wires.
• A red mark on a wire typically designates the location of pin 1.
• A single floppy disk drive ribbon cable has 34 wires and two connectors
to provide for two floppy disk drives.
always connects to drive A, and the connector that does not have
twisted wires always connects to drive B.
• The 80-wire ATA100/66 IDE hard disk drive cable that came with your
system has two connectors to support two drives.
should be used to take advantage of the speed this new technology
offers. The blue connector connects to the onboard IDE connector inter-
face and the other connector(s) to your hard drive(s). Consult the docu-
mentation that came with your disk drive for details on actual jumper
locations and settings for the hard disk drive.
Parallel Port Connector
The parallel port is located on J15.
See the table on the right for pin
definitions.
The connector with twisted wires
Parallel (Printer) Port Pin Definitions
Pin Number
Function
1
Strobe-
3
Data Bit 0
5
Data Bit 1
7
Data Bit 2
9
Data Bit 3
11
Data Bit 4
13
Data Bit 5
15
Data Bit 6
17
Data Bit 7
19
ACK
21
BUSY
23
25
SLCT
5-20
This special cable
(J15)
Pin Number
Function
2
Auto Feed-
4
Error-
6
Init-
8
SLCT IN-
10
GND
12
GND
14
GND
16
GND
18
GND
20
GND
22
GND
PE
24
GND
26
NC
Advertisement
Table of Contents
