Setting Up The System; Checking The Motherboard Setup; Checking The Drive Bay Setup - Supero SUPERSERVER AS-4021GA-62R+F User Manual

S S
UPER ERVER AS-4021GA-62R+F User's Manual
2-3

Setting Up the System

You should fi rst open the left side panel (when facing the front of the chassis) to
make sure the motherboard is properly installed and all connections have been
made.
Warning: Only qualifi ed service technicians should access the inside of
the system. Except for short periods of time, do NOT operate the system
!
without the cover in place. The chassis cover must be in place to allow
proper airfl ow and prevent overheating.

Checking the Motherboard Setup

1. Accessing the inside of the system: Begin by disconnecting the chassis from
any power source. (A) Lift up and back on the main cover handle, which
secures the cover to the chassis. (B) Lift the main cover off of the chassis.
See Chapter 5 for details on Chassis covers and how to remove them.
2. Check the CPU (processor): You may have a processor already installed into
the system board. The processor should have its own heatsink attached. See
Chapter 5 for instructions on processor installation.
3. Check the system memory:
memory already installed. Make sure all DIMMs are fully seated in their slots.
For details on adding system memory, refer to Chapter 5.
4. Installing add-on cards:
the system. See Chapter 5 for details on installing PCI- add-on cards.
5. Check all cable connections and airfl ow: Make sure all power and data cables
are properly connected and not blocking the airfl ow. See Chapter 5 for details
on cable connections.

Checking the Drive Bay Setup

Next, you should check to make sure the peripheral drives and the SATA drives have
been properly installed and all essential connections have been made.
1. Accessing the peripheral drive bays: To install a component to either of the
three 5.25" drive bays, you will need to remove the side chassis cover. See
the installation and removal sections for the peripheral drives in Chapter 6.
Your system may have come with system
If desired, you can install up to seven add-on cards to
2-2