Table of Contents
Advertisement
installation - general
LP Conversion Instructions
This conversion kit shall be installed by a qualified
service agency in accordance with the manufacturer's
instructions and all applicable codes and requirements of
the authority having jurisdiction. If these instructions are
not followed exactly, a fire, an explosion, or production of
carbon monoxide may result causing property damage,
personal injury, or loss of life. The qualified service
agency is responsible for the proper installation of this
kit. The installation is not complete until the operation of
the converted appliance is checked, as specified in the
manufacturer's instructions supplied with the kit.
Conversion Kit 686-969 includes:
1
911-191
Stepper Motor LP for 885 SIT
1
905-046
Orifice #50
1
910-037
Pilot Orifice #30
1
918-590
Decal - Conversion to LP
1
908-528
Label Propane
1
904-529
5/32" long Allen Key
1
920-406
Instruction Sheet
The gas supply shall be shut off prior to disconnecting
the electrical power, before proceeding with the
conversion.
Always let the appliance cool to room temperature before servicing.
1 Remove the outer panels and safety glass — see manual.
2. Remove inner firebox glass — see manual.
3. Remove inner panels — see manual.
4. Remove all media installed on burner (glass, logs or stones, etc).
5. Lift off the far right base panel and loosen 2 screws on IFC cover--re-
moved cover to access IFC.
920-406a
46
| City Series CP60E
CONVERSION FROM NG TO LP
CP60E/CST60E using SIT 885 NOVA Gas Valve
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
IF IN DOUBT DO NOT DO THIS CONVERSION!
6. Disconnect the cable coming from the pressure regulator motor.
7. Remove and discard 2 pressure regulator screws (A) using a (T20 or slot
screwdriver), the pressure regulator (B), and the spring and diaphragm
(C - see below).
8. Ensure that the rubber gasket, prefitted as part of the assembly, is
properly positioned. Install the new pressure regulator using the 2x M4
x .7 screws supplied. Tighten the screws to 25lb-in. In the event that
the screw threads are cross-threaded or stripped, replace the valve as-
sembly.
Install the enclosed propane identification label to the valve body where it is
easily seen.
Pressure
regulator
screws
tooltip
9. Re-attach the pressure regulator wire (disconnected in step 6), re-situate
the IFC, and secure the screws that fasten the IFC mounting brackets.
10. Remove the pilot hood by lifting it up and off.
Pilot hood
11. Lift off the trim cover on the right side of the burner. Also, remove the burner
surround by sliding it to the left and lifting it off.
Trim cover
1
CITY SERIES 60
Cable from motor
Burner Surround
04.07.22
Advertisement
Table of Contents
