Table of Contents
Advertisement
CITY SERIES
9. Install the 4 #5 outer front panels, 2 #5 panels per side as per below.
Also drop in two #7 panels, one in the front and one in the back.
Lastly, place one #8 panel at the end.
One side shown only. Repeat
steps for other side.
FIREPLACE PRODUCTS
INTERNATIONAL
10. Optional: install the glass barrier stopper. If the unit doesn't have
1:24
a glass stopper, proceed to the next step.
SCALE:
11/24/2021
DATE:
DWN:
E.C.N.:
SIGN:
DATE:
DETAIL B
SCALE 1 : 4
FIREPLACE PRODUCTS
INTERNATIONAL
1:24
SCALE:
11/24/2021
920-476
DATE:
DWN:
E.C.N.:
DATE:
SIGN:
A
-
MAT'L :
SHEAR/ PUNCH/ FORM
PROCESS :
CP60 MAIN ASSEMBLY
PART :
PART NO:
457-500
-
MAT'L :
SHEAR/ PUNCH/ FORM
PROCESS :
CP60 MAIN ASSEMBLY
PART :
PART NO:
457-500
installation-panels, barriers, faceplates
11. Slide the side outer #5 glass panels between the wall and the
barrier stopper bracket. If the unit does not have a barrier stopper,
stick the side outer panels to the magnets.
Repeat steps for the remaining 3 outer sides.
12. Install additional glass stoppers at the end of the unit by sliding
the stopper assembly between the unit and panel – the stopper
assembly will attach to the unit via a magnet, adjust position of
glass stopper if required.
REV:
-
DETAIL A
SCALE 1 : 12
A
13. Clean the outer panels wit a cloth before installing the safety
outer barrier glass. To install the safety glass, see this manual
for instructions.
REV:
2
-
3RD ANGLE
TOLERANCES UNLESS
FIREPLACE PRODUCTS
PROJECTION
OTHERWISE STATED
INTERNATIONAL
DIMENSIONS
0.000 = 0.01 CRITICAL
1:24
SCALE:
0.000 = SPECIFIED TOLERANCE
DO NOT SCALE
0.000 = 0.031
DRAWING
DWN:
0.000 REF = REFERENCE ONLY
UNITS IN INCHES
ANGULAR = 1
E.C.N.:
THIS DRAWING IS THE PROPERTY OF FPI LTD., IT MAY NOT BE COPIED IN WHOLE OR IN PART, OR DISCLOSED TO A THIRD PARTY WITHOUT OUR PRIOR WRITTEN CONSENT.
City Series CP60E |
C
3RD ANGLE
TOLERANCES U
PROJECTION
OTHERWISE ST
DIMENSIONS
0.000 = 0.01 CR
0.000 = SPECIFIE
DO NOT SCALE
0.000 = 0.031
DRAWING
0.000 REF = REFE
UNITS IN INCHES
ANGULAR = 1
THIS DRAWING IS THE PROPE
DETAIL B
SCALE 1 : 12
B
-
MAT'L :
SHEAR/ PUNCH/ FORM
PROCESS :
CP60 MAIN ASSEMBLY
PART :
11/24/2021
PART NO:
REV:
DATE:
457-500
-
SIGN:
DATE:
79
12.02.21
Advertisement
Table of Contents
