Password Problems - Epson Powerspan User Manual

Press [numlodt]. If the Num Lock indicator light on the
keyboard lights up, the computer is probably still
processing a command. If it does not light up, proceed to
the next step.
Press [r] 171 [E) or press the reset button to exit the
software program and reboot the computer.
If resetting the computer does not work, turn it off and wait
at least five seconds. If you do not have a hard disk drive,
insert a bootable diskette in drive A. Then turn on the
computer and try running the program again.
If none of these procedures work, check your software
documentation or contact your software manufacturer for
technical support.

Password Problems

If you set a power-on, network, or keyboard password and you
have trouble entering it, check the section below that describes
the problem you are having.
You enter the password, but nothing happens.
Type the password again and press [. You have three
chances to enter a power-on or network password correctly
before the system locks up. If this happens, press the reset
button to reboot the computer and try again. You can try as
many times as necessary to enter a keyboard password.
You want to change of delete the password.
See Chapter 4 for instructions on changing or deleting your
password.
A-16 Troubleshooting