Epson Powerspan User Manual page 139

5. Record the drive's model, serial, and SCSI ID number in the
"Equipment Log" on page 1-11.
6. Follow the instructions in the SCSI drive's documentation
to set any jumpers or switches on the drive and to install or
remove the terminating resistors.
Note
Do not remove terminating resistors from the SCSI
device you install at the end of the ribbon cable. The last
device on the cable terminates the SCSI bus and must
have terminating resistors installed.
7. Using two screws and a grounding clip, attach a plastic slide
rail to each side of the drive. Position each slide rail so its
narrow end is at the socket end of the drive with its tab
facing outward, as shown below. Then install a grounding
clip under each of the two screws nearest the narrow end of
the slide rails.
7-20 Installing and Removing Disk Drives
slide rails