Hard Disk Problems - Epson Powerspan User Manual

Hard Disk Problems

If you think there is something wrong with your hard disk, see
the suggestions below.
with drive.
you have problems a newly-installed
the problem.
carefully followed all the instructions in Chapter 7. Review
the procedures and check all the cable connections to make
sure you installed it correctly. Also check the jumper
settings on your drive to be sure they are set correctly.
you have set the appropriate SCSI ID number for the drive
and that you installed the terminators properly on the first
and last SCSI devices. See your SCSI drive documentation
for more information.
This type of format is usually done by the manufacturer.
Configuration utility to enable the built-in IDE hard disk
controller and have defined your hard disk drive type or
parameters correctly. See Chapters 2 and 3.
prepared properly but you cannot access the drive, review
the instructions in your operating system manual. Make
sure you performed the necessary steps in the installation
process for your configuration.
from whom you purchased the drive.
A-21
Troubleshooting