Removing The Ide Drive Bay Assembly - Epson Powerspan User Manual

Removing the IDE Drive Bay Assembly

Follow these steps to remove the IDE drive bay assembly:
1. Remove any cables that are connected to any drives already
installed in the IDE drive bay assembly.
2. While supporting the IDE drive bay assembly, remove the
screw that attaches it to the computer case at the top of the
bay, as shown below.
3. The other end of the drive bay assembly is secured to the
computer by two anchor tabs inserted into slots in the side
wall. To disengage the tabs, slightly lower the end of the
assembly nearest you and lift up on the end next to the side
wall. Then lift the assembly out of the computer, and place
it on an anti-static surface.
Now follow the instructions in the appropriate section below to
install or remove an IDE drive.
7-10 Installing and Removing Disk Drives
'anchor tab