Password Problems; Accessing Your Current Password - Epson Equity 386/33 PLUS User Manual

Password Problems

If you set a password using the SETUP program, you must
enter it before you can use the system. When you turn on the
computer, it runs a memory test. Then the screen displays the
Enter
Password
password, you cannot use the computer. If you have any
trouble using your password, try the following:
happens, type it again and press m.
change or delete it, see Chapter 2 in the
instructions.
steps below.

Accessing Your Current Password

If you have forgotten your current password and cannot use
your computer, follow these steps:
1. Turn off the computer and follow the instructions under
"Changing the Jumper Settings" in Chapter 4 to disable the
password function by setting jumper J3 to position A.
Caution
Be sure to ground yourself on the back inside panel of
the computer before touching any of the interior
components. Always replace the cover on the computer
before you turn it on again.
2. Turn on the computer. You do not see the Enter Password
prompt.
C-8 Troubleshooting
prompt. If you do not enter the correct
for
Setup Guide