Entering Keyboard Commands - Epson Powerspan User Manual

Entering Keyboard Commands

To change the processor speed, enter one of the keyboard
commands shown in the table below.
Keyboard speed setting commands
Key command
You must use the 1 or 2 key located on the numeric keypad.
When you set the speed to low, you hear a low tone from the
computer's speaker; when you set it to high, you hear a high
tone. The speed setting remains in effect until you press the
reset button or turn off the computer, or until you change the
setting.
Note
You can use these commands while you are running a
program. However, if that program uses the key command
for another function, you cannot use it to change the
processor speed. If this is the case, exit to your operating
system command prompt and try the command or use the
EISA System Utilities to change the speed, as described
below.
4-14 Using
Your
Function
Changes the speed to low (simulated 8 MHz)
Changes the speed to high
Computer