Using Special Modes; Using The Sd Command - Epson Powerspan User Manual

Using Special Modes

You can run the EISA Configuration utility in various special
modes, including non-target modeling mode, by starting the
program with one of the two commands described in this
section. You can also use these commands to run the utility
from a hard disk that runs MS-DOS if you copy the necessary
files to the disk first.
The SD command starts the EISA Configuration utility and also
allows you to run any of the other utilities available on the
Access to other utilities menu. The CF command also starts the
EISA Configuration utility, but you cannot run any other
utilities.
You can run the utilities in different modes by including one or
more parameters on the SD or CF command line, as described
in the next sections.

Using the SD Command

If you want to run the utilities from your hard disk, first follow
the instructions under "Copying the Configuration Files to a
Hard Disk" below. Then follow these steps to use the SD
command:
1. To run the utilities from a diskette, insert the Reference
diskette in drive A and log onto drive A.
To run the utilities from a hard disk, log onto the drive and
directory where you copied the configuration files.
2. Type the following and press m to start the program:
SD [parameters1
Running the EISA Configuration Utility 3-27