Password Problems; Software Problems - Epson Endeavor Pro User Manual

If your drive came with documentation, check there for other
possible solutions to the problem you are having.

Password Problems

You have forgotten your password
You must discharge your CMOS memory. To do this, you
need to change the setting of jumper JP6 to the On position. See
"Changing the Jumper Settings" in Chapter 4 for details.
After you have changed JP6, restart your system, leave it on for
a few seconds, then turn it off again. This resets the SETUP
values to their factory defaults. Both the Supervisor and the
User passwords are disabled.
Set jumper JP6 back to the Off position. Then turn on the
computer again. If you want to set a new password, use SETUP
as described under "Selecting the Security Setup Options" in
Chapter 2.

Software Problems

Your operating system won't s fart after you installed the PCI
IDE drivers.
If you installed PC1 IDE drivers for another operating system,
such as UNIX, make sure you followed the instructions in the
README file for the drivers. See "Installing the PC1 IDE
Drivers"in Chapter 2 for instructions.
Troubleshooting
7 - 1 3