Epson Powerspan User Manual page 36

SETUP program options (continued)
Option
Boot Device
Select
Base Memory
Extended
Memory
Base Memory
Above 512K
Speaker
LCD
Onboard
Mouse
2-8 Running the
Settings
Floppy or Hard
Drive
l
Hard Drive Only
640 KB *
512KB
(memory size]
Enabled *
Disabled
Enabled
l
Disabled
-
Enabled *
Disabled
Program
SETUP
Description
Select the device(s) from which
you want to be able to boot your
system; setting is ignored if the
diskette drive is controlled by
controller on an option card
Displays the size of the base
memory; setting is 640KB unless
there is a base memory failure or
you reassigned the base memory
between 512KB and 640KB in the
option described below
Displays the amount of extended
memory in the system including
memory installed on SlMMs and
any memory option cards; you
cannot change this setting
Set to Enabled to assign the base
memory address from 512KB to
640KB to memory on the system
board; set to Disabled if you
install an option card that
reserves these addresses for its
own use
Set to Enabled to turn on the
computer's built-in speaker; set
to Disabled to turn off the
speaker (cannot be turned on by
application software if Disabled)
This option has no effect on your
system
Set to Enabled if you have
connected a mouse to the
built-in mouse port; set to
Disabled if you are not using a
mouse (frees hardware interrupt
lRQ12) or if you are using a
mouse controller installed on an
option card
a