Removing A Drive From An External Bay - Epson Powerspan User Manual

Removing a Drive from an External Bay

Follow these steps to remove a drive from an external bay:
1. If you have not already done so, remove the front panel
from the system as described in Chapter 5.
2. Notice the tabs on the end of the slide rails attached to each
side of the drive. To release the drive, press each tab in
toward the drive and pull the drive partially out of the bay.
3. While holding the drive in front of the system, disconnect
the power and ribbon cables attached to the drive. Grasp
the cable connector and pull it straight out from the drive
so you do not damage the connector; do not pull on the
cables.
7-8 Installing and Removing Disk Drives