Epson Powerspan User Manual page 61

System board options (continued)
Option
Boot Device
Control
Reserved
System
Resources
* Default setting
1 If you will boot your system from a SCSI hard disk drive, you must disable
the built-in IDE controller and set both hard disk drive types to Disabled.
2 You cannot set Serial Port 1 and 2 to the same address. If you attempt to
do so, you see an error message.
3 If you set the Onboard Video BIOS Mapping option to To C0000H. you
must set the Shadow C0000h - C7FFFh option to Disabled to avoid a
memory conflict. If you set the Onboard Video BIOS Mapping option to
To E0000H, you must set the Shadow E0000h - E7FFFh to avoid a conflict.
4 If you change the refresh rate, you must press the reset button or turn
the computer off and then on again after saving your settings to reset the
rate.
5 The Boot Device Control setting is ignored if the diskette drive is controlled
by a controller on an option card.
Settings
Boot from floppy or
hard drive*
Boot from hard drive
ONLY
(settings vary)
Running the EISA Configuration Utility
Description
Select the device(s) from
which you want to be able to
boot your system (5)
Press w and m to
display the resources, such as
interrupts and port ranges,
that are reserved for use by
the system board
3-19