Epson Powerspan User Manual page 136

4. Connect power cable P7 to the power socket of the drive in
the top half of the drive bay assembly. Connect power cable
P6 to the drive in the lower half of the drive bay assembly.
(If you installed only one drive, connect either P6 or P7; it
does not matter which one.) Be sure to position the
connector so that its notched corners line up with the
notched corners of the socket on the drive. Make sure the
holes fit over all the pins and then push in the connector.
5. Curl up any spare cables and tuck them in the space beneath
the IDE drive bay assembly.
Note
Once you have reassembled the computer, you need to run
the SETUP program or the EISA Configuration utility to
inform the system of your IDE hard disk drive configuration.
For information, see Chapters 2 and 3.
Installing and Removing Disk Drives
7-17