Connections; Aquamaster3 Sensor Connections (Remote Or Close-Coupled Only); Using Tamper-Detection Seals - ABB AquaMaster 3 FET200 User Manual

AquaMaster 3 FET200
Electromagnetic flowmeter Transmitter

3.2 Connections

Note. Refer to Section Fig. 3.4, page 22 for MODBUS connection.

3.2.1 AquaMaster3 Sensor Connections (Remote or Close-Coupled only)

Referring to Fig. 3.4:
1. Remove the screwed cap
2. Gently push the sensor plug
ring.
Note. If the sensor cable is terminated with fly leads, connection is via a sensor cable adapter box
(part number WABC2035 available separately).
Fig. 3.4 Sensor Connections

3.2.2 Using Tamper-Detection Seals

Referring to Fig. 3.5:
1. Pass the wire of the seal through both the hole in the locking-ring and the matching hole in the front
of the transmitter.
2. Close the seal.
Fig. 3.5 Using Tamper-Detection Seals
16
A
on the sensor connector.
B
into the socket and rotate it until it engages, then tighten the locking
3 Electrical Installation
A
B
Security Tag and Seal
OI/FET200–EN Rev. I