Transport And Storage; Inspection; Transporting The Device; Storing The Device - ABB TTH300 Operating Instructions Manual

Head-mount temperature transmitter
Hide thumbs Also See for TTH300:
Table of Contents

Advertisement

6

Transport and storage

6.1

Inspection

Check the devices immediately after unpacking for possible
damage that may have occurred from improper transport.
Details of any damage that has occurred in transit must be
recorded on the transport documents.
All claims for damages must be submitted to the shipper
without delay and before installation.
6.2

Transporting the device

Observe the following instructions:
— Do not expose the device to moisture during transport.
Pack the device accordingly.
— Pack the device so that it is protected against vibrations
during transport, e.g., by using air-cushioned packaging.
6.3

Storing the device

Bear the following points in mind when storing devices:
— Store the device in its original packaging in a dry and
dust-free location.
— Observe the permitted ambient conditions for transport
and storage.
— Avoid storing the device in direct sunlight.
— In principle, the devices may be stored for an unlimited
period. However, the warranty conditions stipulated in the
order confirmation of the supplier apply.
6.3.1

Ambient conditions

The ambient conditions for the transport and storage of the
device correspond to the ambient conditions for operation of
the device.
Adhere to the device data sheet!
6.4

Returning devices

For the return of devices, follow the instructions in the chapter
"Repair" on page 40.
14 OI/TTH300-EN Rev. D | TTH300
7

Installation

7.1

Installation options

There are three options for installing the transmitter:
— Installation in the cover of the connection head (without
springs)
— Direct installation on the measuring inset (with springs)
— Installation on a top-hat rail
7.1.1

Installation in the cover of the connection head

Fig. 11
1. Release the screw plug
head
1
2. Open the
cover.
2
3. Secure
the transmitter 2 at the proper position on the
cover, using the captive screws found in the transmitter.
1
2
3
A10067
3
for the cover of the connection

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tth300-e1hTth300-y0Tth300-e1

Table of Contents