Configuring The Routing Table - Infinity CHECK POINT 1100 Administration Manual

Configuring the Routing Table

The Device > Routing page shows routing tables with the routes added on your appliance.
Note - 1100 appliances support only IPv4 addresses. 1200R and 1400 appliances support both IPv4
and IPv6 IP addresses.
On this page:
• You can add or edit routes and configure manual routing rules. You cannot edit system defined
routes.
•
You can specify routes for and associate IP addresses with selected VPN tunnels. To add,
delete, and modify the IP addresses, use dynamic routing protocols.
For every route:
Table Columns
Destination
Source
Service
Next Hop
Metric
To add a new static route (IPv4 addresses):
1. In Device > Routing, above the Routing Table, click New.
The New Routing Rule window opens with this message: Traffic from any source to any
destination that belongs to any service should be routed through the next hop.
2. Click next hop and select an option in the new window that opens:
• IP Address - Enter the IP address.
• Internet connection - Select an internet connection.
• VPN Tunnel (VTI) - Select the VPN Tunnel.
3. Click OK.
4. Click any source and select an option in the new window that opens:
• Any
• Specified IP address - Enter the IP Address and Mask
5. Click any destination and select an option in the new window that opens:
• Any
• Specified IP address - Enter the IP Address and Mask
Check Point 1100/1200R/1400 Appliances Centrally Managed Administration Guide R77.20.70
Description
The route rule applies only to traffic whose destination matches
the destination IP address/network.
IPv4 only. The route rule applies only to traffic whose source
matches the source IP address/network
IPv4 only. The route rule applies only to traffic whose service
matches the service IP protocol and ports or service group.
The next hop gateway for this route, with these options:
• Specified IP address of the next hop gateway
• Specified Internet connection from the connections configured in the
appliance
• Specified VPN Tunnel Interface (VTI)
Determines the priority of the route. If multiple routes to the
same destination exist, the route with the lowest metric is
selected.
Appliance Configuration
| 72