Table of Contents
Advertisement
To prevent simultaneous login to the Hotspot portal:
1. Go to Device > Advanced Settings.
2. Select Hotspot.
3. Click Edit.
The Hotspot window opens.
4. Click the checkbox for Prevent simultaneous login.
5. Click Apply.
The same user cannot log in to the Hotspot portal from more than one computer at a time.
On the Active Computers page (available through the Home and Logs & Monitoring tabs), you can
revoke Hotspot access for connected users.
Configuring the Routing Table
The Device > Routing page shows routing tables with the routes added on your appliance.
Note - 1100 appliances support only IPv4 addresses. 1200R and 1400 appliances support both IPv4
and IPv6 IP addresses.
On this page:
•
You can add or edit routes and configure manual routing rules. You cannot edit system defined
routes.
•
You can specify routes for and associate IP addresses with selected VPN tunnels. To add,
delete, and modify the IP addresses, use dynamic routing protocols.
For every route:
Table Columns
Destination
Source
Service
Next Hop
Metric
Check Point 1100/1200R/1400 Appliances Centrally Managed Administration Guide R77.20.75
Description
The route rule applies only to traffic whose destination matches
the destination IP address/network.
IPv4 only. The route rule applies only to traffic whose source
matches the source IP address/network
IPv4 only. The route rule applies only to traffic whose service
matches the service IP protocol and ports or service group.
The next hop gateway for this route, with these options:
•
Specified IP address of the next hop gateway
•
Specified Internet connection from the connections configured in the
appliance
•
Specified VPN Tunnel Interface (VTI)
Determines the priority of the route. If multiple routes to the
same destination exist, the route with the lowest metric is
selected.
Appliance Configuration
|
72
Advertisement
Table of Contents
