Infinity CHECK POINT 1100 Administration Manual page 120

6. Install/Update Image from USB
7. Install/Update Boot-Loader from USB
8. Restart Boot-Loader
Please enter your selection :
3. Enter 4 to select Restore to Factory Defaults (local).
4. When you are prompted: "Are you sure? (y/n)" select y to continue and restore the appliance to
its factory defaults settings.
While factory defaults are restored, all LAN Link and Activity LEDs blink orange and green
alternately to indicate progress. This takes up to a few minutes. When completed, the
appliance boots automatically.
1400 appliances only
To restore the Check Point Appliance to its default factory configuration using U-boot
(boot loader):
1. Connect to the appliance with a console connection (use the serial console connection on the
back panel of the appliance).
2. Boot the appliance and press Ctrl-C.
The Gaia Embedded Boot Menu is shown.
Welcome to Gaia Embedded Boot Menu:
1. Start in normal Mode
2. Start in debug Mode
3. Start in maintenance Mode
4. Restore to Factory Defaults (local)
5. Install/Update Image/Boot-Loader from Network
6. Restart Boot-Loader
7. Run Hardware diagnostics
8. Upload preset configuration file
Please enter your selection :
3. Enter 4 to select Restore to Factory Defaults (local).
4. When you are prompted: "Are you sure? (y/n)" select y to continue and restore the appliance to
its factory defaults settings.
While factory defaults are restored, all LAN Link and Activity LEDs blink orange and green
alternately to indicate progress. This takes up to a few minutes. When completed, the
appliance boots automatically.
To disable the reset to default:
Use this CLI command:
>set additional-hw-settings reset-timeout 0
To enable the reset to default:
Use this CLI command:
>set additional-hw-settings reset-timeout 12
Check Point 1100/1200R/1400 Appliances Centrally Managed Administration Guide R77.20.70
Advanced Configuration
| 120