Table of Contents
Advertisement
Configuring the Proxy Server
In the Device > Proxy page, you can configure a proxy server to use to connect to the Check Point
update and license servers.
To configure a proxy server:
1. Select Use a proxy server.
2. Enter a Host name or IP address.
3. Enter a Port.
4. Click Apply.
Backup, Restore, Upgrade, and Other System Operations
In the Device > System Operations page you can:
•
Reboot
•
Restore factory default settings
•
Revert to the factory default image and settings
•
Automatically or manually upgrade
appliance firmware to the latest Check Point version
•
Revert to earlier firmware image
•
Backup appliance settings
desktop computer
•
Restore a backed up configuration
•
Enable IPv6 networking and enforce IPv6 security (1200R and 1400 appliances only)
To reboot the appliance:
1. Click Reboot.
2. Click OK in the confirmation message.
The appliance reboots.
To restore factory default settings:
1. Click Default Settings.
2. Click OK in the confirmation message.
The factory default settings are restored. The appliance reboots to complete the operation.
Note - This does not change the software image. Only the settings are restored to their default
values (IP address https://192.168.1.1:4434, the username: admin and password:
admin).
To revert to the factory default image:
1. Click Factory Defaults.
2. Click OK in the confirmation message.
The factory default settings are restored. The appliance reboots to complete the operation.
Note - This restores the default software image which the appliance came with and also the
default settings (IP address https://192.168.1.1:4434, the username: admin and
password: admin).
Check Point 1100/1200R/1400 Appliances Centrally Managed Administration Guide R77.20.70
("Using the Software Upgrade
("Backing up the System
Wizard" on page 79) the
" on page 80) to a file stored on your
Appliance Configuration
|
77
Advertisement
Table of Contents
