To filter the list:
In the Type to filter box, enter the filter criteria.
The list is filtered.
To refresh the list:
Click the Refresh link.
Viewing Monitoring Data
See Viewing Monitoring Data (on page 49).
Viewing Reports
See Viewing Reports (on page 51).
Using System Tools
See Using System Tools (on page 53).
SNMP
In the Logs & Monitoring > SNMP page you can configure SNMP settings for this gateway.
You can do these actions:
•
Turn the SNMP agent on or off
•
Configure SNMP settings (system location, system contact, and community string for SNMP v1
and v2 authentication)
•
Add SNMP v3 users
•
Configure the settings for SNMP Trap receivers
•
Enable or disable SNMP traps that are sent to the trap receivers
To turn SNMP on or off:
1. Change the SNMP On/Off slider position to ON or OFF.
2. Click Apply.
SNMP must be set to on to configure all SNMP settings (users, traps, and trap receivers).
To configure SNMP settings:
Click Configure.
The Configure SNMP General Settings window opens. You can enable SNMP traps, configure
system location and contact details, and enable SNMP versions in addition to v3.
SNMP v3 Users
•
To add a new SNMP v3 user, click New.
•
To edit an existing SNMP v3 user, select the user from the list and click Edit.
•
To delete an SNMP v3 user, select the user from the list and click Delete.
Check Point 1100/1200R/1400 Appliances Centrally Managed Administration Guide R77.20.70
Appliance Configuration
|
111