Table of Contents
Advertisement
Figure 92
1. Hose clamps
5.
Align the holes in the carbon-canister bracket
with the holes in the fuel tank
Figure 93
1. Screw (#10 x 3/4 inch)
2. Carbon-canister bracket
6.
Assemble the bracket to the tank
with the 4 screws (#10 x 3/4 inch).
7.
Torque the screws to 113 N∙cm (10 in-lb).
g323413
(Figure
93).
g323397
3. Fuel tank
(Figure
93)
Draining the Fuel Tank
Service Interval: Every 400 hours/Yearly (whichever
comes first)
Drain and clean the fuel tank if the fuel system
becomes contaminated or if you plan to store the
machine for an extended period. When cleaning the
fuel tank, use fresh, clean fuel to flush out the tank.
1.
Transfer the fuel from the tank into an approved
fuel container using a siphon pump. Transfer
the fuel from the machine before you pour any
remaining fuel in the tank through the fill spout,
and into a fuel container.
Note:
If you decide to remove the fuel tank,
you will need to disconnect the fuel hose and
electrical connectors from the fuel pump and
sending unit; refer to
and Sending Unit (page
2.
Flush the tank with fresh, clean fuel, if necessary.
3.
Replace the fuel filters; refer to
Fuel Filter (page
4.
Install the tank if you removed it in step 1.
Note:
If you removed the fuel tank, you will
need to connect the fuel hose and electrical
connectors to the fuel pump and sending unit ;
refer to
Installing the Fuel Pump and Sending
Unit (page
65).
5.
Fill the tank with fresh, clean fuel.
66
Removing the Fuel Pump
63).
Replacing the
64).
Advertisement
Table of Contents
