Table of Contents
Advertisement
Figure 104
1. Radiator cap
2. Expansion tank
4.
Check the coolant level in the radiator and in the
expansion tank.
Note:
The radiator should be filled to the top of
the filler neck and the expansion tank filled to
the Full mark on the tank
5.
If the coolant level is low, remove the
expansion-tank cap and the radiator cap, and
fill the expansion tank to the Full mark and the
radiator to the top of the filler neck
Important:
Do not overfill the expansion
tank.
Important:
Do not use water only or an
alcohol/methanol-based coolant.
6.
Install the radiator cap and the expansion-tank
cap
(Figure
104).
g028232
3. Expansion-tank cap
4. Full-line mark
(Figure
104).
(Figure
104).
Coolant Quantity
5.5 L (5.8 US qt); refer to
72)
Changing the Coolant
Service Interval: Every 400 hours/Yearly (whichever
comes first)—Check the coolant (as
directed by the manufacturer) and
change if necessary.
Owner provided equipment: a handheld coolant
thermometer
1.
Position the sprayer on a level surface, engage
the parking brake, shut off the spray pump, shut
off the engine, and remove the key.
2.
Wait until the engine is cool, then remove the
radiator cap
(Figure
3.
Place a large drain pan under the radiator.
4.
Open the drain valve and drain the coolant into
the pan
(Figure
1. Drain valve
5.
Close the drain valve
6.
Remove the radiator cap
7.
Slowly fill the radiator with coolant to
approximately 2.5 cm (1 inch) below the sealing
surface of the cap.
Note:
Use enough coolant to fill the engine
and the system lines. This allows the coolant to
expand without it overflowing while the engine
is warming up.
73
Coolant Specification (page
104).
105).
Figure 105
(Figure
105).
(Figure
104).
g002252
Advertisement
Table of Contents
