Engine-Oil Quantity; Changing The Engine Oil - Toro 41394 Operator's Manual

CAUTION
Components under the seat will be hot
if the sprayer has been running. If you
touch hot components, you may be
burned.
Allow the sprayer to cool before
performing maintenance or touching
components under the hood.
3. Align a drain pan under the engine oil filter
(Figure 80).
Figure 80
1. Drain plug
4. Remove the old oil filter
Note:
Dispose of the used oil filter at a certified
recycling center.
5. Wipe clean the surface of the oil filter adapter of
the engine with a rag.
6. Fill the oil filter with the specified oil.
Note:
Allow the filter element to saturate with
oil.
7. Apply a thin coat of the specified oil to the rubber
gasket on the replacement oil filter.
8. Install the oil filter to the filter adapter and turn
the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter
an additional 1/2 turn
Note:
Do not overtighten the oil filter.
9. Wipe clean any residual oil.

Engine-Oil Quantity

5.1 L (5.4 US qt) with the filter; refer to
Specification (page 59)
g028169
2. Engine oil filter
(Figure 80).
(Figure 80).
Engine-Oil

Changing the Engine Oil

Service Interval: After the first 50 hours
Every 200 hours Change the oil more often
when operating the machine under heavy load
or in high temperatures.
1. Align a drain pan under the drain plug
80).
2. Remove the drain plug
oil to drain completely.
Note:
Check the drain plug seal for wear
and damage; replace the seal if it is worn or
damaged.
Note:
Dispose of the used oil at a certified
recycling center.
3. Install the drain plug into the drain port of the
engine oil pan and tighten the plug to 33 to 37
N∙m (24 to 27 ft-lb).
4. Tilt the passenger seat forward and align the
prop rod into the detent in the prop-rod-guide
slot.
5. Remove the oil-filler cap from the filler neck of
the valve cover of the engine
slowly pour approximately 80% of the specified
amount of oil into the filler neck.
1. Low
2. Full
3. High
6. Remove the dipstick and check the oil level in
the engine (Figure
7. Slowly add additional specified oil to bring the oil
level to the full mark on the dipstick
Important:
Overfilling the engine with oil
may cause damage to the engine.
60
(Figure
(Figure 80) and allow the
(Figure 81) and
Figure 81
4. Oil-filler cap
5. Dipstick
81).
(Figure
g195189
81).