Toro 41394 Operator's Manual page 85

Figure 123
Section-Valve Actuator Shown (the agitation valve actuator
1. Actuator (section valve)
2. Retainer
3. Remove the actuator from the manifold valve.
Removing the Agitation-Manifold
Valve
1. Remove the quick connect pin that secures the
quick-connect coupler for the agitation hose to
the manifold for the agitation valve
Figure 124
1. Flange (pressure-filter
head)
2. Flange (coupling adapter)
3. Flange clamp
is similar)
3. Stem port
(Figure
4. Quick-connect pin
5. Quick-connect coupler
(agitation hose)
6. Quick-connect fitting
(agitation-valve manifold)
2. Remove the 3 flange clamps that secure the
agitation-valve manifold to the flanges of the
pressure-filter head and the coupling adapter
(Figure
3. Remove the 2 flange-head bolts (1/4 x 3/4 inch)
and 2 flange locknuts (1/4 inch) that secure the
agitation-valve manifold to the valve support
(Figure
g032545
1. Manifold (agitation valve)
124).
2. Valve support
3. Flange locknut (1/4 inch)
4. Remove the agitation-valve manifold and
gaskets from the machine
Note:
If needed, loosen the mounting hardware
for the pressure-filter head as needed to provide
clearance.
Note:
Retain the flange clamps, gaskets, and
quick-connect pins for installation in
the Agitation-Manifold Valve (page
Removing the Section-Manifold
Valve
1. Remove the quick-connect pin that secures the
g191301 quick-connect coupler for the section-bypass
valve to the section-manifold valve
85
124).
125).
Figure 125
4. Flange-head bolt (1/4 x
3/4 inch)
5. Gasket
(Figure
g191302
125).
Installing
89).
(Figure 126).