Table of Contents
Advertisement
Installing the Forward Heat Shield
1.
Align the rear flange of the forward heat shield
over the forward flange of the rear heat shield
(Figure
67).
Figure 67
1. Front of the machine
2. Hex-head bolts and
washers
2.
Align the holes in the forward heat shield with
the threaded holes in the chassis
3.
Assemble the forward heat shield to the machine
with the 6 hex-head bolts and 6 washers
67) that you removed in step
Forward Heat Shield (page
4.
Torque the bolts to 1978 to 2542 N∙cm (175 to
115 in-lb).
5.
Remove the jack stands and lower the machine.
g028177
3. Rear flange (forward heat
shield)
4. Forward flange (rear heat
shield)
(Figure
67).
(Figure
3
of
Removing the
52).
Removing the Undercarriage
Shroud
1.
Remove the 5 flange-head bolts (5/16 x 7/8
inch) and 5 washers (5/16 inch) that secure the
rear of the undercarriage shroud to the chassis
of the machine
Note:
Retain the flange-head bolts and
washers for installation in step
Undercarriage Shroud (page
1. Flange-head bolts (5/16 x
7/8 inch)
2. Undercarriage shroud
2.
Remove the 4 flange locknuts (5/16 inch) from
the bolts and carriage bolt that secure the
mounting tabs of the undercarriage shroud
to the engine-mount brackets of the machine
(Figure
69).
Note:
Do not remove the bolts from
the machine. Retain the flange locknuts
for installation in step
Undercarriage Shroud (page
53
(Figure
68).
5
of
Installing the
54).
Figure 68
3. Washers (5/16 inch)
4. Front of the machine
3
of
Installing the
54).
g189584
g189585
Advertisement
Table of Contents
