Toro 41394 Operator's Manual page 65

Turf sprayer with excelarate spray system
Hide thumbs Also See for 41394:
Table of Contents

Advertisement

Installing the Fuel Pump and
Sending Unit
1.
Support the float arm and pickup tube together
and slip the float and fuel filter into the opening
in the fuel tank
(Figure
Important:
Ensure that the float and the
long leg of the filter are pointing forward in
the tank and the fitting at the top of the fuel
pump points 90° toward the centerline of the
machine.
2.
Seat the fuel pump/sending unit into the opening
in the tank
(Figure 88
3.
Install the seal and nut over the fuel
pump/sending and onto the neck of the fuel tank
and tighten the nut hand tight
4.
Connect the coupling on the fuel hose to the
fitting of the fuel pump
Note:
Ensure that the locking sleeve of the
fuel-hose coupling secures the coupling to the
pump fitting.
5.
Connect the 2-socket connector of the
machine-wiring harness to the 2-pin connector
of the fuel pump/sending unit; Connect the 2-pin
connector of the machine-wiring harness to the
2-socket connector of the fuel pump/sending
unit
(Figure
88).
6.
Rotate the starter switch to the O
check the fuel-hose coupling for leaks.
Note:
If the coupling leaks, rotate the starter
switch to the O
FF
remove the coupling, check the coupling and
fitting for dirt or damage, and install the hose
and coupling onto the fitting.
Note:
Repair any fuel leaks before proceeding
to the next step.
Installing the Fuel Pump Cover
1.
Assemble the cover to the tank
the 4 screws (#10 x 3/4 inch) that you removed
in step
2
of
Removing the Fuel Pump Cover
(page
62).
88).
and
Figure
89).
(Figure
88).
(Figure
88).
position and
N
position, remove the key,
(Figure
90) with
1. Screws (#10 x 3/4 inch)
2. Cover
2.
Torque the screws to 113 N∙cm (10 in-lb).
Installing the Carbon Canister
Machine Model 41394
1.
Align the fuel tank hoses through the grommets
of the carbon-canister bracket
2.
Assemble the hose clamps over the hoses
(Figure
91).
3.
Assemble the hoses onto the fittings of the
carbon canister
4.
Secure the hoses to the fittings with the clamps
(Figure
92)
65
Figure 90
3. Fuel tank
(Figure
91).
Figure 91
(Figure
91).
g323402
g323414

Advertisement

Table of Contents
loading

This manual is also suitable for:

Multi pro 5800-g41394ca

Table of Contents