Table of Contents
Advertisement
to Using the Sub-Area Screen in the Software
Guide for the Multi Pro 5800-D and 5800-G turf
sprayer with ExcelaRate spray system.
Note:
When you move to a different job site,
you need to select another sub-area screen
to record the individual area and volume
information.
6.
If you need to switch the active rate between
the rate 1 value and the rate 2 value, from the
InfoCenter home screen press buttons 1 and 2
simultaneously to select
4 and 5 simultaneously to select
to the Software Guide for the Multi Pro 5800-D
and 5800-G turf sprayers with ExcelaRate spray
system.
7.
Set the spray section switch(es) to the O
position
(Figure
45).
Figure 45
1. Left spray-section switch
2. Center spray-section
switch
8.
Set the agitation switch and the spray-pump
switch to the O
position
N
1 or press buttons
RATE
2; Refer
RATE
N
g192944
3. Right spray-section switch
4. Master section switch
(Figure
46).
1. Sprayer-pump switch
2. Agitation switch
9.
Set the throttle to the F
10.
Drive at the desired speed and then set the
master section switch to the O
spraying
(Figure
Note:
Use the master section switch to start
and stop the flow of chemical s to the selected
spray sections.
11.
When finished spraying, set the master section
switch to the O
sections, then set the spray-pump switch to the
O
position.
FF
Note:
Raise the outer spray sections to the
transport position and drive the sprayer to the
cleaning area.
Important:
Always raise the boom sections
until they have moved completely into
section-transport cradle forming the "X"
transport position and the lift cylinders
are fully retracted whenever you move the
sprayer from 1 spraying area to another, or
move to a storage or cleaning area.
Spraying in the Manual Mode
Note:
This procedure assumes that the spray pump
is on; refer to
Figure 46
Rate Mode (page
37).
1.
Ensure that the sprayer system is adjusted for
the active spray nozzles that you have selected;
refer to
Preparing the Machine (page
2.
Set the sprayer mode button to the Manual
Mode
(Figure
38
Figure 46
3. Throttle
position
(Figure
AST
position to begin
N
45).
position to turn off all spray
FF
in
Spraying in the Application
47).
g192636
46).
30).
Advertisement
Table of Contents
