Table of Contents
Advertisement
Figure 129
1. Valve open
2.
Remove the 2 end-cap-fitting assemblies from
each end of the manifold body
Figure
131).
Figure 130
Agitation Valve Manifold
1. Stem retainer
2. Valve stem
3. Stem port
4. Stem-capture retainer
5. End-cap fitting
6. End-cap seal O-ring
(0.796 x 0.139 inch)
2. Valve closed
(Figure 130
and
7. Back seating O-ring (0.676
x 0.07 inch)
8. Valve-seat ring
9. Manifold body
10. Ball valve
11. End-cap-fitting assembly
g027562
1. Valve-stem seat
2. Valve-stem assembly
3. Stem port
4. Stem retainer
5. Outlet fitting O-ring (0.737
x 0.103 inch)
6. Coupling (manifold)
3.
Turn the valve stem so that the ball is in the
open position
Note:
When the valve stem is parallel with the
valve flow, the ball slides out.
g028243
4.
Remove the stem retainer from the slots in the
stem port in the manifold
131).
5.
Remove the stem retainer and valve stem seat
from the manifold
6.
Reach into the manifold body and remove the
valve-stem assembly
131).
7.
Clean the inside of the manifold and exterior
of the ball valve, valve-stem assembly, stem
capture, and end fittings.
87
Figure 131
Section Valve Manifold
7. End-cap O-ring (0.796 x
0.139 inch)
8. Back seating O-ring (0.676
x 0.07 inch)
9. Ball seat
10. Manifold body
11. Ball valve
12. Coupling assembly
(manifold)
(Figure
129A).
(Figure 130
(Figure 130
and
(Figure 130
g028240
and
Figure
Figure
131).
and
Figure
Advertisement
Table of Contents
