Table of Contents
Advertisement
1. Hose clamps
4.
Separate the hoses from the fittings
5.
Remove the hose clamps from the hoses
86).
6.
Remove the carbon canister from the fuel tank
(Figure
86).
Removing the Fuel Pump and
Sending Unit
1.
Disconnect the 2-socket connector of the
machine-wiring harness from the 2-pin
connector of the fuel pump/sending unit;
disconnect the 2-pin connector of the
machine-wiring harness from the 2-socket
Figure 85
(Figure
Figure 86
connector of the fuel pump/sending unit
87).
g323399
86).
1. 2-socket connector
(machine—wiring
harness)
2. 2-pin connector (fuel
pump/sending unit)
3. 2-pin connector
(machine-wiring harness)
4. 2-socket connector (fuel
pump/sending unit)
2.
Slide the locking sleeve of the fuel-hose coupling
away from the fitting of the fuel pump/sending
unit and remove the coupling and hose from the
fitting
Note:
hose coupling or fuel-pump fitting.
g323398
3.
Rotate the nut for the fuel pump/sending unit
counterclockwise and remove the nut and seal
(Figure
(Figure
4.
Carefully lift and rotate the fuel pump/sending
unit out of the neck of the fuel tank
Important:
fuel pump/sending unit to avoid damaging
the arm for the float of the sending unit.
63
Figure 87
5. Nut (fuel pump/sending
unit)
6. Seal
7. Fitting (fuel pump)
8. Fuel-hose coupling
(Figure
87).
Clean up any fuel that flows from the
87)
Use caution when handling the
(Figure
g323401
(Figure
88).
Advertisement
Table of Contents
