Draining The Fuel Tank - Toro 41393 Operator's Manual

4. Disconnect the 2 hoses from the hose fittings,
and allow any fuel in the hoses to drain into an
approved fuel container
5. Rotate the fuel-standpipe/sender cap
counterclockwise, then remove the cap
77).
1. Fuel-standpipe/sender
cap
2. Fuel-standpipe/sender
assembly
6. Lift the fuel-standpipe/sender assembly from the
fuel tank (Figure
Note:
Discard the old standpipe assembly.
Installing the In-Tank Fuel Filter
Note:
Obtain the new stand pipe assembly from
your local Authorized Toro Dealer. You may need a
new seal to secure the elbow fitting and standpipe
assembly to the top of the fuel tank.
1. Assemble the standpipe cap over the stand pipe
and the standpipe to the seal
2. Align the cap, standpipe, and seal to the tank,
and carefully insert the new stand-pipe assembly
into the fuel tank
Note:
Align the hose fittings toward the center
line of the machine.
3. Thread the cap onto the neck of the fuel tank
and tighten the cap hand tight
4. Assemble the 6.4 mm (1/4 inch) fuel hose onto
the 6.4 mm (1/4 inch) hose fitting, and secure
the hose to the fitting with the hose clamp
(Figure 76).
(Figure 76).
Figure 77
3. Seal
77).
(Figure 77).
(Figure 77).
(Figure 77).
5. Assemble the 8 mm (5/16 inch) fuel hose onto
the 8 mm (5/16 inch) hose fitting, and secure the
hose to the fitting with the hose clamp
76).
(Figure 6. Assemble the cover to the tank with the 4 screws
(#10 x 3/4 inch) that you removed in step
Removing the In-Tank Fuel Filter (page
7. Torque the screws to 113 N∙cm (10 in-lb).

Draining the Fuel Tank

Service Interval: Every 400 hours/Yearly (whichever
Drain and clean the fuel tank if the fuel system
becomes contaminated or if you plan to store the
machine for an extended period. When cleaning the
fuel tank, use fresh, clean fuel to flush out the tank.
1. Transfer the fuel from the tank into an approved
fuel container using a siphon pump, or remove
the tank from the machine and pour the fuel out
of the tank-fill spout into the fuel container.
Note:
g028691
to remove the fuel supply and return hoses from
the standpipe assembly before removing the
tank; refer to steps
In-Tank Fuel Filter (page
2. Replace the fuel filters; refer to the
the Water-Separator Filter (page
3. Flush the tank with fresh, clean fuel, if necessary.
4. Install the tank if you removed it; refer to step
through
(page
5. Fill the tank with fresh, clean fuel.
61
comes first)
If you remove the fuel tank, you will need
1 though
60).
5 in Removing the In-Tank Fuel Filter
60).
(Figure
2 of
60).
4 in Removing the
Replacing
60).
1