Table of Contents
Advertisement
Assembling the Manifold Valve
Operator supplied material: Clear silicone grease.
Important:
Use only silicone grease when
assembling the valve.
1.
Check the condition of the outlet fitting O-rings
(section valve manifold only), end cap O-rings,
back seating O-rings, and ball seat for damage
or wear
(Figure 130
Note:
Replace any damaged or worn O-rings
or seats.
2.
Apply silicone grease to the valve stem and
insert it into the valve stem seat
Figure
131).
3.
Install the valve stem and seat into the manifold
and secure the stem and seat with the stem
retainer
(Figure 130
4.
Ensure that the back seating O-ring and the ball
seat are aligned and seated into the end-cap
fitting
(Figure 130
5.
Install the end-cap fitting assembly onto the
manifold body until the flange of the end-cap
fitting touches the manifold body
and
Figure
131), then turn the end-cap fitting an
additional 1/8 to 1/4 turn.
Note:
Use caution so as not to damage the end
of the fitting.
6.
Insert the ball into the valve body
Note:
The valve stem should fit inside the ball
drive slot. If the valve stem does not fit, adjust
the position of the ball
Figure 132
7.
Turn the valve stem assembly so that the valve
is closed
(Figure
8.
Repeat steps
4
and
fitting assembly.
and
Figure
131).
(Figure 130
and
Figure
131).
and
Figure
131)
(Figure 130
(Figure
(Figure
132).
129B)
5
for the other end-cap
Installing the Section-Manifold
Valve
1.
Align the 2 gaskets that you removed in
Removing the Section-Manifold Valve (page
85)
to the flanges of the section-valve manifold
(Figure
Note:
for the left or right section-valve manifolds as
needed to provide clearance.
and
1. Flange locknut (1/4
132).
inch—left and right
section-valve manifold
positions)
2. Section-bypass valve
3. Quick-connect fitting
(section-valve manifold)
2.
Align the flange of the section-valve manifold
between the flanges of the other section-valve
(s) and/or coupling adapter
3.
Assemble the quick-connect fitting of the
section-valve manifold to the quick-disconnect
socket of the section-bypass valve with a
quick-connect pin
g027565
88
133).
If needed, loosen the mounting hardware
Figure 133
4. Flange (coupling adapter)
5. Gasket
6. Flange-head bolt (1/4 x
3/4 inch—left and right
section-valve manifold
positions)
(Figure
(Figure 133
g191304
133).
and
Figure
134).
Advertisement
Table of Contents
