Table of Contents
Advertisement
2.1.2 Loading the Angle Rotor
The rotor must be loaded evenely on all positions, (see Figures 7 and 8). This reduces the wear of
drive and the acoustic operating noise.
For this rotor, only use capillary tubes that do not exceed the dimensions of Ø 1.9 mm x 75 mm
Figure 7: WRONG
2.1.3 Removing the Rotor
Untighten the rotor nut completely, counter-clockwise. Lift the rotor vertically out of the centrifuge
(see Figure 6).
2.2 Power Switch, Fuse
The power switch and the fuse are located on the back side of the centrifuge (Figure 9).
Figure 9
In case of a faulty fuse, first disconnect the power cord from the mains supply.
Then open the fuse drawer and replace the fuse with 2.5 AT.
If the fuse triggers again after mains connection, please search the cause of the error and eliminate
it.
© Hermle Labortechnik GmbH
Figure 8: RIGHT
Z207H_V1.22_eng
OPERATING
Fuse drawer and fuse 2.5 AT
13
Advertisement
Table of Contents
