WAGO 2789-9080 Product Manual page 31

2789-9080
Removal
NOTICE
!
Material damage due to hot swapping!
Hot swapping the product leads to increased abrasion of the contacts. Resulting in a
shorter product life time.
• Only remove the product when it is switched off.
1. Press the top locking tab (a) of the product [C].
2. Pivot the product to remove it from the WAGO Power Supply Pro 2 [D].
NOTICE
!
Avoid electrostatic discharge!
The products are equipped with electronic components that you may destroy by electro-
static discharge when you touch. Please observe the safety precautions against electro-
static discharge in accordance with EN 61340-5-1/-3. Pay attention while handling the
products to good grounding of the environment (persons, job and packing).
| Version: 1.1.0
Communication Module IO-Link
Installation and Removal
C
D
Figure 8: Removal
31