Buttercups Installation - Damper Shaft - SRAM RockShox ZEB Ultimate Flight Attendant Service Manual

2 0 0 H o u r S e r v i c e
1
Install the upper ButterCups housing and bushing assembly onto the Install the upper ButterCups housing and bushing assembly onto the
damper shaft. Slide the assembly toward the rebound seal head until damper shaft. Slide the assembly toward the rebound seal head until
it stops. it stops.
2 Install a new upper ButterCups bumper, wide end first, onto the Install a new upper ButterCups bumper, wide end first, onto the
damper shaft. damper shaft.
3 Apply Threadlocker Loctite 2760 (red), or equivalent, to the first three Apply Threadlocker Loctite 2760 (red), or equivalent, to the first three
full threads on the end of the end plate. full threads on the end of the end plate.
4 Clamp the damper shaft into the 10 mm slot of the Reverb Vise Blocks Clamp the damper shaft into the 10 mm slot of the Reverb Vise Blocks
or RockShox Rear Shock Vise Blocks. or RockShox Rear Shock Vise Blocks.
Clamp the damper shaft only tight enough so it does not spin when the Clamp the damper shaft only tight enough so it does not spin when the
ButterCups housing is tightened. ButterCups housing is tightened.
Scratches on the damper shaft can cause oil to leak. If a scratch is
visible the rebound damper assembly may need to be replaced.
Thread the ButterCups shaft end plate into the damper shaft and Thread the ButterCups shaft end plate into the damper shaft and
tighten it. tighten it.
B u t t e r C u p s I n s t a l l a t i o n - D a m p e r S h a f t
NOTI CE
Threadlocker Loctite 2760 - Red
T25 RockShox Vise Blocks 10 mm

ButterCups Installation - Damper Shaft

SRAM Butter Grease
T25 5 N∙m (45 in-lb)
55