SRAM RockShox ZEB Ultimate Flight Attendant Service Manual page 45

5 Clamp the damper shaft into the 10 mm slot of the RockShox Reverb Clamp the damper shaft into the 10 mm slot of the RockShox Reverb
Vise Blocks or RockShox Rear Shock Vise Blocks with the damper Vise Blocks or RockShox Rear Shock Vise Blocks with the damper
oriented downward. oriented downward.
Clamp the damper shaft only tight enough so it does not spin when the Clamp the damper shaft only tight enough so it does not spin when the
ButterCups shaft end plate is removed. ButterCups shaft end plate is removed.
Scratches on the damper shaft can cause oil to leak. If a scratch is
visible the rebound damper assembly may need to be replaced.
Unthread and remove the ButterCups shaft end plate from the damper Unthread and remove the ButterCups shaft end plate from the damper
shaft. shaft.
6
Remove the upper ButterCups bumper and discard it. Remove the upper ButterCups bumper and discard it.
Remove the upper ButterCups housing and bushing assembly from the Remove the upper ButterCups housing and bushing assembly from the
damper shaft. damper shaft.
NOTI CE
T25 RockShox Vise Blocks 10 mm
ButterCups Removal - Damper Shaft
45