Table of Contents
Advertisement
8
Apply a small amount of grease to the end of the rebound adjuster rod
Apply a small amount of grease to the end of the rebound adjuster rod
to assist with installation.
to assist with installation.
Install the rebound adjuster knob onto the rebound damper bottom
Install the rebound adjuster knob onto the rebound damper bottom
bolt.
bolt.
Press the knob firmly onto the bolt until it clicks into place.
Press the knob firmly onto the bolt until it clicks into place.
Tighten the set screw.
Tighten the set screw.
Refer to your pre-service recorded rebound setting to adjust the
Refer to your pre-service recorded rebound setting to adjust the
rebound damping.
rebound damping.
9
Refer to your pre-service recorded settings, or use the air chart on the
Refer to your pre-service recorded settings, or use the air chart on the
fork's lower leg, and pressurize the air spring.
fork's lower leg, and pressurize the air spring.
You may see a drop in the indicated air pressure on the pump gauge
You may see a drop in the indicated air pressure on the pump gauge
while filling the air spring; this is normal. Continue to fill the air spring to
while filling the air spring; this is normal. Continue to fill the air spring to
the recommended air pressure.
the recommended air pressure.
Compressing the fork will equalize the positive and negative air
Compressing the fork will equalize the positive and negative air
chambers. After the fork is cycled 3-4 times, check the pressure and
chambers. After the fork is cycled 3-4 times, check the pressure and
add air as needed.
add air as needed.
Install the air valve cap.
Install the air valve cap.
10
Clean the entire fork.
Clean the entire fork.
This concludes the service of your RockShox suspension fork.
This concludes the service of your RockShox suspension fork.
SRAM Butter Grease
Shock pump
RockShox Suspension Cleaner
2.5 mm
3.3 N∙m (29 in-lb)
67
Lower Leg Installation
Advertisement
Table of Contents
