SRAM RockShox ZEB Ultimate Flight Attendant Service Manual page 27

5 Clamp the air shaft into the 10 mm slot of the RockShox Reverb Vise Clamp the air shaft into the 10 mm slot of the RockShox Reverb Vise
Blocks or RockShox Rear Shock Vise Blocks with the air piston oriented Blocks or RockShox Rear Shock Vise Blocks with the air piston oriented
downward. downward.
Clamp the air spring shaft only tight enough so it does not spin when Clamp the air spring shaft only tight enough so it does not spin when
the ButterCups shaft end plate is removed. the ButterCups shaft end plate is removed.
Scratches on the air spring shaft can cause air to leak. If a scratch is
visible the air spring assembly may need to be replaced.
Unthread and remove the ButterCups shaft end plate from the air Unthread and remove the ButterCups shaft end plate from the air
spring shaft. spring shaft.
6
Remove the ButterCups shaft end plate o-ring (large) and discard it. Remove the ButterCups shaft end plate o-ring (large) and discard it.
The small o-ring does not need to be removed or replaced. The small o-ring does not need to be removed or replaced.
7 Remove the air spring shaft from the vise and vise blocks. Remove the air spring shaft from the vise and vise blocks.
Remove the upper ButterCups housing and bushing assembly from the Remove the upper ButterCups housing and bushing assembly from the
air spring shaft and set it aside. air spring shaft and set it aside.
NOTI CE
T25 RockShox Vise Blocks 10 mm
ButterCups Removal - Air Spring Shaft
27