Installing The Right Control Panel - Dell EMC PowerEdge R450 Xeon 4309Y Installation And Service Manual

Figure 125. Removing right control panel
3. Holding by the sides, remove the right control panel assembly away from the system.
Next steps

Installing the right control panel

Installing the right control panel
Prerequisites
Follow the safety guidelines listed in
Steps
1. Route the control panel cable through the side wall of the system.
2. Align the right control panel assembly with the control panel slot on the system and attach the control panel assembly to the
system.
3. Connect the control panel cable to the connector on the system board and lower the cable latch to secure the cable in place.
4. Using a Phillips #1 screwdriver, tighten the screws to secure the right control panel assembly to the system.
Safety instructions.
Installing and removing system components 127