Table of Contents
Advertisement
b. Tighten the second screw completely.
c. Return to the first screw and tighten it completely.
If the PHM slips off the blue retention clips when the screws are partially tightened, follow these steps to secure the PHM:
a. Loosen both the heat sink screws completely.
b. Lower the PHM on to the blue retention clips, following the procedure described in step 2.
c. Secure the PHM to the system board, following the replacement instructions listed in this step above. 4.
Figure 63. Installing the processor and heat sink module
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
Expansion cards and expansion card risers
Expansion card installation guidelines
The following table describes the supported expansion cards:
Table 22. Expansion card riser configurations
Expansion card riser
Full height right riser
Low profile right riser
Low profile left riser
Butterfly riser
Butterfly riser
NOTE:
The expansion-card slots are not hot-swappable.
74
Installing and removing system components
After working inside your
PCIe slots on the
riser
Slot 2
Slot 2
Slot 3
Slot 2
Slot 3
system.
Processor
Height
connection
Processor 1
Full Height
Processor 1
Low Profile
Processor 2
Low Profile
Processor 1
Full Height
Processor 1
Low Profile
Length
Slot
width
Half Length
x16
Half Length
x16
Half Length
x16
Half Length
x16
Half Length
x8
Advertisement
Table of Contents
