Installing A 3.5-Inch Drive Adapter Into The 3.5-Inch Drive Carrier - Dell EMC PowerEdge R450 Xeon 4309Y Installation And Service Manual

Figure 48. Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier
Next steps

Installing a 3.5-inch drive adapter into the 3.5-inch drive carrier

Installing a 3.5-inch drive adapter into the 3.5-inch drive carrier
Prerequisites
1. Follow the safety guidelines listed in
2. Install the 2.5-inch drive into the 3.5-inch drive adapter.
Steps
1. Insert the 3.5-inch drive adapter into the 3.5-inch drive carrier with the connector end of the drive toward the back of the
3.5-inch drive carrier.
2. Align the screw holes on the 3.5-inch drive adapter with the holes on the 3.5-inch drive carrier.
3. Using a Phillips #1 screwdriver, secure the 3.5-inch drive adapter to the 3.5-inch carrier.
NOTE: If the 3.5-inch drive has Torx screw, use Torx 6 screwdriver to remove the drive from a 3.5-inch drive adapter.
58 Installing and removing system components
Safety instructions.