Table of Contents
Advertisement
Figure 23. Installing the front bezel with the LCD panel
System cover
NOTE:
The system cover of 12 x 3.5-inch + 2 x 3.5-inch (rear) system is different from other systems. The cover has one
additional mylar and foam layer on the front side of the system cover.
Removing the system cover
Prerequisites
1. Follow the safety guidelines listed in
2. Turn off the system, including any attached peripherals.
3. Disconnect the system from the electrical outlet and disconnect the peripherals.
Steps
1. Using a 1/4 inch flat head or a Phillips #2 screwdriver, rotate the latch release lock counter clockwise to the unlocked
position.
2. Lift the latch till the system cover slides back and the tabs on the system cover disengage from the guide slots on the
system.
3. Hold the cover on both sides, and lift the cover away from the system.
34
Installing and removing system components
Safety
instructions.
Advertisement
Table of Contents
