Table of Contents
Advertisement
Signal Generator Overview
Rear Panel Overview (N5166B, N5171B, N5172B, N5181B, & N5182B)
8. 10 MHz OUT
Connector
female BNC
Signal
A nominal signal level greater than 4 dBm.
9. GPIB
This connector enables communication with compatible devices such as external controllers, and is
one of three connectors available to remotely control the signal generator (see also
11. Device
USB).
10. LAN
The signal generator supports local area network (LAN) based communication through this
connector, which enables a LAN–connected computer to remotely program the signal generator.
The LAN interface supports auto–MDIX. The signal generator is limited to 100 meters on a single
cable (100Base–T). For more information on the LAN, refer to the Programming Guide.
11. Device USB
Connector
Type B
USB Protocol
Version 2.0
Use this universal serial bus (USB) connector to connect a PC to remotely control the signal
generator.
12. Host USB
Connector
Type A
USB Protocol
2.0
Use this universal serial bus (USB) to connect a USB Flash Drive (UFD) for data transfer. You can
connect or disconnect a USB device without shutting down or restarting the signal generator.
13. SD Card
Holds the Secure Digital (SD) nonvolatile memory card.
32
Impedance nominally 50 Ω
Keysight CXG, EXG, and MXG X-Series Signal Generators User's Guide
10. LAN
and
Advertisement
Table of Contents
