11. Preset And User Preset; Rf Output (N5166B, N5171B, N5172B, N5181B, N5182B); Rf Output (N5173B, N5183B); 13. Rf On/Off And Led - Keysight N5166B CXG User Manual

11. Preset and User Preset

These hardkeys set the signal generator to a known state (factory or user–defined). See
the Signal Generator" on page

12. RF Output (N5166B, N5171B, N5172B, N5181B, N5182B)

Connector Standard:
Option 1EM:
Impedance:
Damage Levels 50 Vdc, 2 W maximum RF power

12. RF Output (N5173B, N5183B)

Connector Option 513/520:
Option 532/540:
Option 1ED Option
1EM:
Impedance:
Damage Levels 0 Vdc, 0.5 W maximum RF power

13. RF On/Off and LED

This hardkey toggles the operating state of the RF signal present at the RF OUTPUT connector. The
RF On/Off LED lights when RF output is enabled.

14. Mod On/Off and LED

This hardkey enables or disables the modulation of the output carrier signal by an active
modulation format. This hardkey does not set up or activate a format (see
Signal" on page 74).
The MOD ON/OFF LED lights when modulation of the output is enabled.

15. Page Down

In a table editor, use this hardkey to display the next page. See
page 62. When text does not fit on one page in the display area, use this key in conjunction with the
Page Up key (page 24) to scroll text.

16. I Input (vector models only)

Connector Type: female BNC Impedance: 50 Ω
Signal An externally supplied analog, in–phase component of I/Q modulation.
The signal level is
Damage Levels 1 V
rms
See also, "I/Q Modulation" on page
Keysight CXG, EXG, and MXG X-Series Signal Generators User's Guide
60.
female Type–N
Rear panel output
50 Ω
male Precision APC-3.5
male Precision 2.4 mm
female Type–N
Rear panel output
50 Ω
= 0.5 V for a calibrated output level.
rms
265.
Signal Generator Overview
Front Panel Overview
"Modulating the Carrier
"Example: Using a Table Editor" on
"Presetting
25